The electronic transformer calibration software is divided into three functional interfaces: error verification, parameter settings, and communication settings. This article uses the WD-807 transformer tester from Wuhan Gaodian Electric as an example to briefly introduce the functions and operation methods of each interface.
1. Communication Settings
The communication settings interface is used to set communication parameters related to the calibrator control module. Here, you can test the communication with the calibrator control module. The interface is shown in the figure below:
By default, this interface does not require any settings. When the software is opened, the serial port will be opened automatically. Settings only need to be changed when you need to modify the configuration or perform communication tests.
The data receiving area displays received data, communication frames, etc., while the data sending area stores the data to be sent. The data here is sent to the control module of the calibrator.
Setting instructions:
² Serial Port Number: Select the serial port number used for communication with the calibrator control module. It is fixed to COM2.
² Baud Rate: Select the baud rate for communication. The default is 57600.
² Parity Bit: You can choose odd parity, even parity, or no parity. The default is no parity.
² Stop Bit: Select the number of stop bits for serial communication. The default is 1 stop bit.
Hello! How can I help you?
Main Products: Dielectric Loss Tester, Transformer Ratio Tester, Loop Resistance Tester, HV Wireless Phase Detector, Insulation Resistance Tester, Partial Discharge Tester, Cable Fault Tester, DC Resistance Tester, etc.